ASTM D Standard Test Method for Ball-Pan Hardness of Activated Carbon. Standard Test Method for Ball-Pan Hardness of Activated Carbon. Status: Withdrawn · Replaced by: ASTM D Buy this standard. Price: SEK. PDF. D()活性碳的球盘硬度的试验方法 – Designation: D Referenced Documents ASTM Standards: B 19 Speci?cation for.

Author: Kagajin Dikus
Country: South Sudan
Language: English (Spanish)
Genre: Environment
Published (Last): 9 December 2013
Pages: 419
PDF File Size: 2.7 Mb
ePub File Size: 10.34 Mb
ISBN: 669-2-71839-593-3
Downloads: 7052
Price: Free* [*Free Regsitration Required]
Uploader: Kesar

Summary of Test Method 4. Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address d3082 at phonefaxor service astm. The adhesion of material atsm sieves, brushes, etc. Humidity effects during a given test will largely cancel out if no change in humidity occurs between 9. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.

Apparatus and Materials 6. Place the hardness test sieve on top of the receiving pan.

Standard Test Method for Ball-Pan Hardness of Activated Carbon

Table 1 lists the hardness test sieve corresponding to each minimum nominal sieve. Obtain at least mL of material within the nominal mesh size range. Tyler Model SB, available from W.


Weigh to the nearest 0. At the end of this period, the amount of particle size degradation is determined by measuring the quantity of carbon, by weight, which is retained on a sieve whose openings are closest to one half the openings of the sieve that de?

Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. Use additional material obtained as in 9. Current edition approved June 29, If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below. One supplier tested 31 samples of a single grade of carbon and obtained an average hardness of A number in parentheses indicates the year of last reapproval.

Fit the cover plate with a cork stopper which extends from 3.

Adjust the bottom stops to give a clearance of approximately 1. BoxGastonia, NChas been found to be satisfactory.

Precision and Bias Discard the fractions above the larger and below the smaller nominal particle size. The value of H2 gives the upper limit of hardness, if we ignore the effects of humidity. Sieves shall be calibrated at reasonable intervals in accordance with the procedure described in Speci?

Conceding the fact that the test does not actually measure in-service resistance to degradation, it can be used to establish the comparability of lots ostensibly of the same grade of carbon.


ASTM D – 16 Standard Test Method for Ball-Pan Hardness of Activated Carbon

Pour the screened and weighed sample into the hardness pan and add the steel balls. The extra sieves, in this case, serve only to form a stack which? None of these has proved completely satisfactory for all applications, and all have been questioned by ASTM Committee D on Activated Carbon as tests for establishing degradation resistance. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters.

Shake with the hammer operating for 10 min 6 10 s.


It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A superscript epsilon e indicates an editorial change since the last revision or reapproval.

This standard is subject to revision d38022 any time by the responsible technical committee and must be reviewed every?

Author: admin